Customer App
Universal adapter For cooling system tester
Univ. adap., cool. sy. test. 27–42 mm
UNIADAPT-F.CLSYSTEST-085350
Register now and access more than 10,000 products
Datasheets(X)
1. Adapter rubber and opening to be sealed must be free of oil, grease and glycol residues
2. Press the adapter into the radiator opening or expansion tank and seal by rotating the two adjustment wheels against one another
3. Connect radiator tester
4. Pump approx. 1.3 bar into the cooling system using the hand pump
5. The pressure in the cooling circuit must not drop by more than 0.2 bar within 10 minutes.
6. In the event of a drop in pressure, localise and eliminate potential points of leakage (e.g. water pump, hoses, cylinder head seal)
Caution: The universal adapter should never be immersed in cooling fluid as this causes fluid leakage at the valve when the pressure is released.
Last viewed
System assortment 4.4.1, screwdriver 8 pieces
Raised contersunk head tapping screw, C shape with H recessed head DIN 7983, A2 stainless steel, plain. With cross recess.
Application nozzle Standard For 310 ml plastic cartridges
Pipe and fastening clamp Multifix
Hand tap, taper tap HSS DIN 352
Countersunk tapping screw shape C with H recessed head DIN 7982, A2 stainless steel, with tip
3/8-inch socket wrench for TX screws, short
C 6.3 TX bit (1/4 inch)
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, ≤ M24 A2-70 stainless steel, ≥ M24 A2-50 stainless steel
Thread die HSS DIN EN 22568 for standard metric ISO threads